top of page
To test this feature, visit your live site.
Trouble setting the height on classic 9” jmw arm.
I’ve loosened the set screws in the base and turn the ships wheel without success, help
Trouble setting the height on classic 9” jmw arm.
I’ve loosened the set screws in the base and turn the ships wheel without success, help
1 comment
Comments (1)
bottom of page
Hey Kelly, thanks for being part of the VPI family and reaching out on the forum. I'm a but curious about your table/arm because I don't believe we ever made a Classic with a 9" JMW arm unless it was a customer/DIY situation. Would you be able to post pictures so I can measure twice and cut once on this to make sure its all the same base/parts. Technically loosening the base screws with an allen wrench should be all you need. Did you loosen both the back on side set screw? Talk soon!